Bonsenkitchen VS3802 Vacuum Sealer

Operating Instructions - Page 5

For VS3802. Also, The document are for others Bonsenkitchen models: VS3801, VS3803

PDF File Manual, 14 pages, Read Online | Download pdf file

VS3802 photo
Loading ...
Loading ...
Loading ...
5
If the consignment is incomplete or damaged due to defective packaging or carriage,
Please contact us.
Installation Requirements
For safe and trouble-free operation of the device, the set-up location must fulfill the
following requirements:
When setting it up, place the appliance on a firm, flat and horizontal surface.
Do not place the device in a hot, wet or extremely damp environment or in the
vicinity of flammable materials.
The mains power socket must be easily accessible, so that the power cable can be
easily disconnected in the event of an emergency.
Electrical Connection
Before you connect the appliance, compare the connection data (voltage and
frequency) on the data plate with that of your mains power network. These data must
agree so that no damage issue stained by the device.
Ensure that the power cable is undamaged and is not routed over hot surfaces
and/or sharp edges.
Ensure that the power cable is not taut or kinked.
Do not let the power cable hang over edges (trip wire effect).
Insert the plug into the mains power socket.
Sealing Vacuum bags
The bag width may not exceed 11.81Inch. Otherwise it cannot be welded correctly.
Use only nylon-PE films with a structure (points or grooves) on one side and that have
a structure(points or grooves) on one side and a thickness of approximately 0.006
-0.012 inch(6.8- 11.6mil).Otherwise the weld seam will not be tight and the appliance
may be damaged. You can recognize bags of this type from the information on the
packaging. The quality of the weld seam will vary depending on the type and
thickness of the bag.
Cut the desired length for your bag from the roll. Open the appliance lid by pressing
the lid release and open the lid up wards .Lay the open end of the bag as far into the
appliance so that the opening of the bag is located central under the lower sealing
ring. The bag should be inserted no further than the behind sealing ring and must lie
between the front sealing ring. If the bag lies over one or both of the two sealing ring,
then the bag cannot be correctly welded.
The bag opening must lie flat on the welding wire. Otherwise the welding does not
Loading ...
Loading ...
Loading ...