Loading ...
Loading ...
Loading ...
STEP 2
Removing the shipping bolts
Before using your washer, you must remove the four
shipping bolts from the back of the unit.
1, Loosen all the bolts with the supplied wrench.
2, Slide the bolt and spacer up and remove the bolt with
the spacer through the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fill the holes with the supplied bolt hole covers.
4. Keep the shipping bolts and spacers for future use.
STEP 3
Installing your washer
1. Place the drain hose in the drain facility.
Be sure an airtight connection is NOT
made between the drain hose and the
standpipe.
The standpipe must be at least 18in.(46
cm) high.
_ Caution must always be exercised to
avoid collapsing or damaging the drain
hose. For best results, the drain hose
should not be restricted in any way - by
elbows, couplings, or excessive lengths.
For situations where the drain hose
cannot be conveniently elevated to at
least 18in.(46 cm), the drain hose must
be supported.
LaundP tub
Tie
strap
Guide
Stand pipe
96" Max
,18" Min
2= Before connect the inlet hoses to water faucets, check to
ensure a washer is inside coupling.
Washer
setting up your new wash ng mach ne 15
WF409ANW-02657D-02 EN.indd 15 2009-12-04 L.4.,4.ii11:19:40
Loading ...
Loading ...
Loading ...