Loading ...
Loading ...
Loading ...
3
MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATIO N AND PERSO NAL
SAFETY, WE RECOMMEND TH AT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If your cabinet is metal, use the nylon
grommet aroun d th e power cord hole to preven t
cuttin g of th e cord.
NOTE: We recommen d using filler blocks if the
cabinet front han gs below th e cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
Insert a self-aligning screw th rough top cen ter
cabinet h ole. Temporarily secure th e oven by
turn ing the screw at least two full turns after the
th reads have engaged. ( It will be completely
tighten ed later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
2
Rotate front of oven
up again st cabinet
bottom.
NOTE: When mounting the
microwave oven , th read
power cord th rough h ole in
bottom of top cabinet. Keep
it tigh t through out Steps
1–3. Do n ot pinch cord or
lift oven by pulling cord.
Lift microwave, tilt it
forward, an d hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
1
CHECK FOR PROPER
DAMPER OPERATION
Exhaust Adaptor
Blow er Plate
Damper
Back of
M icrow ave
• Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
• You will need to make adjustments to assure proper
alignmen t with your house exh aust duct after the
microwave is installed.
A3.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST
Secure blower unit to microwave with th e screw
5
removed in Step 1. Make sure the screw is tigh t.
Replace blower plate with th e screw removed in
Step 1. Make sure th e screw is tight.
Back of
M icrow ave
6
7
Back of
M icrow ave
Guide
Adaptor
Locking Tab
damper swings freely.
Attach the exhaust adaptor to th e top of the
blower plate by sliding it into the guides
of th e
blower plate.
Push in securely until it is in the locking
tabs.
Take care to assure th at th e damper hin ge
is
installed so th at th e
A4.
A5.
Installation Instructions
IMPORTANT: Do not grip or use the handle
or heat shield during installation. Do not
remove the cardboard spacers between the
heat shield and door.
EN-14
Loading ...
Loading ...
Loading ...