Loading ...
Loading ...
Loading ...
Service menu
Turn/
Push
Display Comments/instructions
SP:xxxxDate the software was programmed (Year_Week)
TRACKINGDATA
CM:xxxxDate of manufacture of the control unit (Year_Week)
SV:xxxxxxxxxSoftware version number
NCP0:xxxxxxxxxTotal number of cycles run
NCP1:xxxxxxxxxNumber of cycles run for Programme 1
NCP2:xxxxxxxxxNumber of cycles run for Programme 2
NCP3:xxxxxxxxxNumber of cycles run for Programme 3
NCP4:xxxxxxxxxNumber of cycles run for Programme 4
NCP5:xxxxxxxxxNumber of cycles run for Programme 5
NCP6:xxxxxxxxxNumber of cycles run for Programme 6
NCP7:xxxxxxxxxNumber of cycles run for Programme 7
NCP8:xxxxxxxxxNumber of cycles run for Programme 8
NCP9:xxxxxxxxxNumber of cycles run for Programme 9
NCP10:xxxxxxxxxNumber of cycles run for Programme 10
NCP11:xxxxxxxxxNumber of cycles run for Programme 11
”Fault No. of cycles(1)” Last three faults and number of cycles (when the fault occurred) shown. A total reset
deletes the fault indications from the system. If the same fault recurs at different times,
this is shown, but only once in the list.
FAILURE REEDD OUT
”Fault No. of cycles (2)”
”Fault No. of cycles (3)”
Opening the service menu
+
Check that the machine is switched off. Otherwise switch off the main power by pressing the main power switch
(S1).
Press and hold the Start button (S2) while turning on the main power with the main power switch (S1).
Press the Start button (S2) 5 times within 5 seconds. The service menu is now activated, as seen in the display
window. The service menu can be closed by turning off the power with the main power switch (S1).
Press the Stop button (S3) to navigate the menu system step by step.
Turn the programme selector (J1) to make selections from the menus.
Confirm the selection and continue to the next menu by pressing the Stop button (S3).
Press the Start button (S2) to confirm the settings and exit the service menu.
x 5
Panel key: S = Push button, J = Knob
S3
J1 DISPLAY
S2
S1
Service Manual TD70.C
30
Loading ...
Loading ...
Loading ...