Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
TO REMOVE HOOD AND GRILL ASSEMBLY TO ADJUST CARBURETOR
(See Fig. 29)
• Raise hood.
• Unsnap headlight wire connector.
• Standinfrontoftractor. Grasphoodatsides, tilttoward
engine and liftoff of tractor.
• To replace, reverse above procedure.
HEADLIGHTWIRE
CONNECTOR
RG. 29
ENGINE
TO ADJUST THRO'B'LE CONTROL CABLE
(See Fig. 30)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment
as described below before loosening cable. Ifadjustment
is necessary, proceed as follows:
• With engine not running, move throttle control lever to
fast position.
• Check that swivel is against stop. If it is not, loosen
cable clamp screw and pull cable back until swivel is
against stop.Tighten cable clamp screw securely.
TO ADJUST CHOKE CONTROL (See Fig. 31)
The choke control has been preset at the factory and ad-
justment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
With engine not running, move choke control (located
on dash panel) to full choke position.
• Loosen knob and remove cover assembly from air
cleaner.
• Choke should be closed. Ifit is not, loosen casing clamp
screw and move choke cable until choke iscompletely
closed. Tighten casing clamp screw securely.
• Replace air cleaner cover assembly and tighten
knob.
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take yourtractor to an authorized service center for repair
and/or adjustment.
High speed stop isfactory adjusted. Do not adjust - dam-
age may result.
IMPORTANT:NEVERTAMPERWITHTHEENGINEGOVERNOR,
WHICH IS FACTORYSET FOR PROPER ENGINE SPEED.
OVERSPEEDINGTHE ENGINE ABOVETHE FACTORYHIGH
SPEED SE'R'INGCAN BE DANGEROUS. IFYOU THINKTHE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACTYOURNEARESTAUTHORIZED SERVICECENTER/
DEPARTMENT, WHICH HAS PROPER EQUIPMENT AND
EXPERIENCETO MAKEANY NECESSARYADJUSTMENTS.
SWIVEL
FIG. 30
CLAMP SCREW
FIG. 31
25
Loading ...
Loading ...
Loading ...