Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST-
MENTS
• Depress clutch/brake pedal fully and set parklng brake.
• Place motion control lever in neutral (N) position.
• Place attachment clutch in "DISENGAGED" position.
• Turn ignitlon key to"STOP" and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Dlsconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE MOWER (See Fig. 17)
Mower will be easier to remove from the right side of trac-
tor.
• Place attachment clutch in =DISENGAGED" position.
• Move attachment lift lever forward to lower mower to
its lowest position.
• Roll belt off engine pulley.
• Remove small retainerspring, and remove clutchspring
off pulley bolt.
• Remove large retainer spring, slidecollar off and push
housing guide out of bracket.
• Disconnect anti-swaybar from chassis bracket by re-
moving retainer spring.
• Disconnect suspension arms from rear deck brackets
by removing retainer springs.
• Disconnect front linksfrom deck by removing retainer
springs.
• Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT: IF AN A'I-I'ACHMENT OTHERTHAN TH EMOWER
DECK ISTO BE MOUNTED ONTHE TRACTOR, REMOVETHE
FRONTLINKSAND HOOKTHECLUTCH SPRING INTOSQUARE
HOLE IN FRAME.
SMALL RETAINER
CLUTCH SPRING'
SMALL RETAINERSPRING
CLUTCH SPRING
TO INSTALL MOWER (See Fig. 17)
• Raise attachment lift lever to its highest position.
• Slide mower under tractorwith deflector shieldto right
side of tractor.
• Lower liftlever to its lowest position.
• Connect front links to mower deck and secure with
retainer springs..
• Connect suspension arms to rear deck brackets and
secure with retainer springs.
• Connect anti-swaybar to chassis bracket and secure
with retainer spring.
• Push clutchcable housingguide intobracket, slidecol-
lar onto guide and secure with large retainer spring.
• Place flat washer and clutch springon idler pulley bolt
and secure with small retainer spring.
• Install belt onto engine pulley.
__ SQUARE HOLE
ENGINE PULLEY
FRONT LINK
RETAINER .=
ANTI-SWAY
COLLAR
RETAINER SPRINGS
(BOTH SIDES)
HOUSING GUIDE
LARGE RETAINER
SPRING
BRACKET
DEFLECTOR SHIELD
Fig. 17
2O
Loading ...
Loading ...
Loading ...