Loading ...
Loading ...
Loading ...
OPERATION
iMPORTANT SAFETY iNSTRUCTiONS
To reduce the risk of SEVERE INJURY or DEATH:
1. READAND FOLLOWALL WARNINGSAND
INSTRUCTIONS.
2. ALWAYS keep remote controls out of reach of children.
NEVERpermit children to operate or play with garage door
control push buttons or remote controls.
3. ONLY activate garagedoor when it can be seen clearly, it
is properly adjusted, and there are no obstructions to door
travel.
4. ALWAYS keep garage door in sight until completely
closed. NO ONESHOULDCROSSTHE PATH OFTHE
MOVING DOOR.
5. NO ONESHOULDGO UNDERA STOPPED,PARTIALLY
OPENEDDOOR.
6. If possible, use emergency releasehandleto disengage
trolley ONLYwhen garagedoor is CLOSED.Weak or
broken springs or unbalanceddoor could result in an open
door failing rapidly and/or unexpectedly, causing SEVERE
INJURYor DEATH.
7. NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
8. NEVERuse handle to pull garage door open or closed. If
rope knot becomes untied, you could fall.
9. If one control (force or travel limits) is adjusted, the other
control may also needadjustment.
10. After ANY adjustments are made, the safety reversal
system MUST betested.
11. Safety reversal system MUST be tested every month.
Garagedoor MUST reverse on contact with
1-1/2" (3.8 cm) high object (or a 2x4 laid fiat) on the floor.
Failure to adjust the garage door opener properly may
causeSEVEREINJURYor DEATH.
12. ALWAYS KEEPGARAGEDOORPROPERLYBALANCED
(see page3). An improperly balanceddoor may NOT
reversewhen required and could result in SEVEREINJURY
or DEATH.
13. ALL repairs to cables, spring assembliesand other
hardware, ALL of which are under EXTREMEtension,
MUST be made by a trained door systems technician.
14. ALWAYSdisconnect electric power to garagedoor opener
BEFOREmaking ANY repairs or removing covers.
15SAVETHESEINSTRUCTIONS.
Using YourGarageDoor Opener
Your Security+ _eopener and hand-held remote control have been
factory-set to a matching code which changeswith each use,
randomly accessing over 100 billion new codes. Your opener will
operate with up to eight Security÷ _eremote controls and one
Security÷ ® KeylessEntry System. If you purchasea new remote
control, or if you wish to deactivate any remote control, follow the
instructions in the Programming section.
Activateyour opener with any of the following:
• The hand-held Remote Control: Hold the large push button
down until the door starts to move.
• The waft-mounted Door Control: Hold the push button or bar
down until the door starts to move.
• The KeylessEntry (SeeAccessories): If provided with your
garage door opener, it must be programmed before use.
See Programming.
When the opener is activated (with the safety reversingsensor
correctly installed and aligned)
1. if open, the door will close, if closed, it will open.
2. if closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open position, it will
close.
5. If obstructed while closing, the door will reverse, if the
obstruction interrupts the sensor beam,the opener lights will
blink for five seconds.
6. If obstructed while opening, the door will stop.
7. If fully open, the door will not close when the beam is broken.
The sensor has no effect in the opening cycle.
If the sensor is not installed, or is misaiigned, the door won't
close from a hand-held remote control. However, you can close
the door with the Door Control or Keyless Entry, if you activate
them until down travel is complete. If you releasethem too soon,
the door will reverse.
The opener lights will turn on under the following conditions:
when the opener is initially plugged in; when power is restored
after interruption; when the opener is activated.
They wiii turn off automatically after 4-1/2 minutes or provide
constant light when the Light feature on the Premium Control
ConsolePanel is activated. Bulb sizeis A19. Bulb power is
100 watts maximum.
Security.I"° light feature: Lights will also turn on when someone
walks through the open garage door. With a Premium Control
Console,this feature may be turned off as follows: With the
opener lights off, press and hold the light button for 10 seconds,
until the light goes on, then off again. To restore this feature, start
with the opener lights on, then press and hold the light button for
10 seconds until the light goes off, then on again.
3O
Loading ...
Loading ...
Loading ...