Loading ...
Loading ...
Loading ...
m
Wall Sleeve Brands: #6Whirlpool
17 1/8" Deep
Lou_am
_1_ 3"5'_I _o _
Top_ew
F4_O=
1. Redirect the louvers atthe back of the wall sleeve as shown
opposite. The use of pliers is recommended.
2. Cut (2) 17"Tapered Spacer Blocksas shown below into
two pieces. _
3. install to the floor of the sleeve as shown.This helps
induce a rearward slope on the unit,
4. Attach (1) 1 ½" x 3/8" x 25" longseal in the center at the
top of the sleeve. Remove the backing paper and press
into position.
5. Attach (2) 1 ½" x 3/8" x 14" seals to the left and right
sides of the sleeve.
6.Cut (2) 1½" x 3/8" x 25" longseals to 14" long each
and attach to the vertical sections of the grilleas shown.
7. Center unit& gently slide unit into sleeve.
8. Before slidingall-the-way back, remove 2rid screw from front
on left side of unit.
9. Remove the plasticwasher from the screw.
10. Screw and attach the other end of the ground wire to the
unitas shown in picture. Make sure that the toothed washer
is against the cabinet.
11. Slide the unit completely to bherear to ensure a good seal,
making sure the ground wire does not become tangled.
12. Seal & Frame the unitas described on the last page of
these instructions.
8
Loading ...
Loading ...
Loading ...