Loading ...
Loading ...
Loading ...
Wall Sleeve Brands:
#9 White Westinghouse or Frigidaire 22. Deep
,
if the wall sleeve does nothave a rear grille or Iouvered
panel, installthe plasticgrillefrom the kit. The plastic
grille ismounted to the inside of the wall sleeve at the rear
flanges. There are (4) plastic nuts inthe flanges of the wall
sleeve. If some are missing replacements are included in
the accessory kit, and can be simply pressed intothe square
holes in the flanges. Place the grille against the rear flanges
and use the (4) large washers and screws to secure the grille.
Because of the increased unit depth, first try dry fitting
using the method described below:
2. Place (2) 1 ½" x 1 ½" x 14" seals against each side.
3. Gently slide unit inand check ifamount extending from the
sleeve issufficientonce the trimframe is attached.
4. if positionis okay, remove unitand Proceed to the next step.
if not go to step 8.
5. Attach (1) 1 ½" x 1 ½" x 25" long seal inthe center at the
top of the sleeve. Remove the backing paper and press into
position.
6. Attach (2) 1 ½" x 1 ½" x 14" seals to the left and right sides
of the sleeve.
7. Cut (1) t ½" x 1 ½" x 25" longseal to 14" long and attach it
vertically to the rear grill3.5" from the left side. Repeat and
attach 3" from the rightside.
Use the next steps if the unit requires extra extension into
the room.
8. Attach 1"x _" 14" long seal over the solid vertical portion of
the rear grille.
9. Attach (2) 4 ½" x 3 ½° x 1 ½" foam blocks withthe slot
overlapping the seal above.
10. install the divider intothe slots of the foam blocks.You may
need to trim the length to size.
11. Repeat steps 8-10 for the other vertical shown portion of
the grille as shown in the picture.
12. Cut to fit the 1 ½" x 1 ½" x 25" seal to fit the top of the sleeve.
The pieces must be fitted flush to the edge of the divider.
13. Attach (2) 1 V2"x 1 ½"x 14" seals along the sides of the
sleeve again making sure all seals are flush,
14. Center unit& gently slide unit intosleeve.
15. Before slidingall-the-way back, remove 1st screw from front
on left side of unit.
16. Remove the plasticwasher from the screw.
17. Screw and attach the other end of the groundwire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet.
18. Slide the unit completely to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
19. Seal & Frame the unitas described on the last page of
these instructions.
11
Loading ...