Loading ...
Loading ...
Loading ...
#3 Fedders or Friedrich 16 %" Deep
1. Redirect the louvers atthe back of the wall sleeve as shown
opposite. The use of pliers is recommended.
2. Attach (2) 4 ½" x 3 ½" x 1 ½" centering/supportblocks one on
each side wall. Place in center of side wall withthe tapered
end facing the opening.
3. Cut (2) 17" Tapered Spacer Blocksas shown below intothree
pieces.
4, The 2 ½" section is placed in front of the rib on base with the
tapered end facing the back of the sleeve. Cut the remaining
portionto 12 ½" and place behind the rib again sloping toward
the tear of the sleeve. This helps induce a rearward slope on
the unit,
5. Attach (1) 1 ½" x 3/8" x 25" longseal in the center at the
top of the sleeve. Remove the backing paper and press
into position.
6, Attach (2) 1 ½" x 3/8" x 14" seals to the left and rightsides
of the sleeve,
7, Cut (2) 1½" x 3/8" x 25" long seals to 14" longeach
and attach to the vertical sections of the grille as shown.
8. Gently slide unitinto sleeve.
9. Before slidingall-the-way back, remove 2nd screw from front
on left side of unit.
10. Remove the plasticwasher from the screw.
11. Screw and attach the other end of the ground wire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet,
12, Slide the unit completely to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
13, Seal & Frame the unitas described on the last page of
these instructions.
5
Loading ...
Loading ...
Loading ...