Loading ...
Loading ...
Loading ...
7
APPLIANCE GAS CONNECTION
IMPORTANT: This appliance must be installed by an authorised person.
WARNING: DO NOT MODIFY THIS APPLIANCE
If the appliance cannot be adjusted to perform correctly, contact the service department.
This appliance utilises a threaded 1/2" gas male fitting.
To connect the appliance to the gas network with a flexible hose, a supplemental hose nipple fitting is needed which is
supplied with the appliance. (Fig. 07)
Gas inlet positions with different leg heights – mm
Gas inlet (mm) - Nat gas Gas inlet (mm) – ULPG
From RH rear side: 70 mm From RH rear side: 70mm
Up from floor cooker with worktop stamped: 655 - 725mm Up from floor cooker with worktop stamped: 570 - 640mm
Up from floor cooker with worktop welded: 675 - 745mm Up from floor cooker with worktop welded: 590 - 660mm
Gas Regulator
The gas connection is via 1/2" tapered thread. Connect the cooker to the gas supply and test for leaks. NEVER use a naked
flame to check for gas leaks.
Natural Gas: Gas regulator supplied with the appliance must be installed.
ULPG: Test point adaptor to be fitted and checked at time of installation.
Using a flexible connection
This appliance is approved for connection with a flexible hose, which complies with the AS/NZS 1869 (AGA
Approved), 10mm ID, class B or D, between 1-1.2m long. Connection shall be in compliance with AS/NZS 5601.
When installing the hose restraint device, the appliance anchor point is the rear panel.
Using a Copper Pipe connection
We recommend that the isolation valve be fitted prior to the cooker to enable isolation of the cooker from the gas supply.
The valve must be easily accessible at all times.
To find out the gas type factory settings, see label on the rear of the appliance.
Fig. 07
Loading ...
Loading ...
Loading ...