Loading ...
Loading ...
Loading ...
5
IMPORTANT INFORMATION FOR INSTALLING AND SERVICING THE APPLIANCE
The cooker can be installed separately, as a freestanding unit, or between kitchen units or between a kitchen unit and the wall.
This appliance is not connected to devices which exhaust combustion products.
Special attention must be focused on the prescriptions described below regarding room aeration and ventilation.
The dimensions of the appliance are listed below:
LENGTH DEPTH HEIGHT with worktop stamped HEIGHT with worktop welded
897mm 600mm adjustable 870-940mm adjustable 890-960mm
Fig.2 Fig.3
APPLIANCE SERVICING
IMPORTANT!
ALL SERVICING AND MAINTENANCE ARE TO BE COMPLETED BY THE MANUFACTURER’S AUTHORISED
PERSONNEL ONLY.
Before carrying any servicing operation disconnect the appliance from gas and electric supply and extra appliance from final
installation place in order to have access to the appliance for proper servicing intervention.
STEP 1: PRESSURE REGULATOR.
For NG or ULPG installation ref. to fig. 7 and chapter ‘Appliance gas connection’ at pag 7
STEP 2: SURFACE BURNERS
For surface burners conversion ref to table 1 chapter ‘Adaption to various types of gas’ at page 8 and chapter
‘Conversion to different types of gas’ at page 12
STEP 3: MAIN OVEN BURNER
For main oven burner conversion ref to table 1 chapter ‘Adaption to various types of gas’ at page 8 and chapter
‘Conversion to different types of gas’ at page 12
STEP 4: VISUAL CHECKS
The following visual check must be performed to ensure that the conversion has been carried out properly and without
damage to other components of the range. Verify that the flame of the oven burner be completely blue and with regular
aspect as shown below.
CONNECTION OF THERMOCOUPLE TO THERMOSTAT
The thermocouple for oven burner is connected to the magnet. Tight gently the connection.
The tip of the spark plug or thermocouple must fully overlap at least the first gas emission hole of the burner.
After performing all these visual checks, reinstall the bottom panel of the oven compartment and proceed to setting the
minimum for each burner.
STEP 5: MINIMUM FLAME ADJUSTMENT
WARNING!
These adjustments should be made only for use of the appliance with Natural gas. For use with ULPG, the bypass screw
must be fully turned in a clockwise direction.
Surface burners
Cooker with worktop stamped Cooker with worktop welded
Loading ...
Loading ...
Loading ...