Loading ...
Loading ...
Loading ...
Attach the engine mounting plate to the tongues
using two 3/8" x 3" hex bolts in the back holes, two
3/8" x 1" hex bolts in the front holes and four 3/8"
nylock nuts. See figure 7.
HINT: For easier assembly, support the rear tongue with
a block of wood.
3/8" × 3"
HEX BOLT 6
i i
3/8" NYLOCK NUT
3/8" x 1"
HEX BOLT
Place the hose hanger rod down into the hose hanger
bracket on the impeller housing assembly. See figure
9.
HOSE HANGER
ROD
\
\\\ \
\ \
\ \
\
\
FIGURE 9
FIGURE 7
* Attach the plastic elbow to the top of the engine
housing using four 5/16" x 3/4" hex bolts (self
tapping) and nylon washers. See figure 8.
HINT: Push in on hex bolts as you tighten to form threads.
* Connect the hose adapter to the engine housing by
fastening three wing nuts to the pre-assembled bolts
in the engine housing. See figure 8.
Place a hose clamp onto the end of the hose. Push
the hose onto the hose adapter (nozzle). Tighten the
hose clamp onto the hose and hose adapter. Do not
collapse the hose adapter when tightening the clamp.
See figure 10.
The remaining hose clamp will be used later to fasten
the hose to the deck adapter.
NYLON WASHER ---_
HOSE ADAPTER
(NOZZLE)
b5/16" X 3/4"
HEX BOLT
(SELFTAP)
FIGURE 8
HOSE CLAMP
FIGURE 10
Cal11-866-576-8388formissingpartsorassemblyhelp 11
DO NOT RETURN TO STORE
Loading ...
Loading ...
Loading ...