Loading ...
Loading ...
Loading ...
So ving epe ati sg p eb ems
Is the power switched on at the wall?
Unplug from wall. Wait 60 seconds, plug back in, turn on and try again.
Could household power supply be at fault? Try plugging in another appliance.
Key Lock Mode may be activated. Try holding down the POWER button for 3 seconds. (Refer to
page 34.)
Are both hot and cold faucets turned on?
Are the inlet hose filters blocked? Check the ends of the hoses.
Ensure drain hose is located instandpipe or set tub/sink.
Ensure standpipe or set tub/sink is at least 33 1/2"(850 ram) high and no more than 96"
(2438 ram) high.
Ensure load isnot out of balance.
Check washer is level and does not rock.
Ensure washer does not have suds buildup.
Clothes are unevenly distributed in wash tub, your washer has slowed the spin to compensate.
Your washer is designed to automatically sense load size and minimize water use, therefore
the water level may look different to your previous washer, this is normal.
This unique wash system uses two wash phases. The second phase can be cooler than the first
to minimize energy use. This is normal and will not affect wash performance.
Ensure than you are using a High Efficiency (HE) detergent.
Try using a little less detergent, especially if garments are only lightly soiled.
Loading ...
Loading ...
Loading ...