Loading ...
Loading ...
Loading ...
Before you for service N761
:Check that the cold water supply has been turned on.
Your cold water temperature may exceed the recommended limits (refer to
:: Installation instructions pages 6 - 11).
Checkthat the inlet hose filter is not blocked.
Check that the inlet hose filte r is no t kinked or squashed. ...............................................................
Check that the inlet hoses have been connected to the correct faucets.
The flow rate of the supply water may be too slow.
"l_ O:V:E@LO_ DED" ::i::i::i::i::i::i :
Your washer is overloaded and cannot continu e the cycle. ...........
:: Ensure the washer is stationary and remove items until the remaining ones can
: move freely.
Check that the washer is not siphoning (refer to installation instructions pages 6 - 11).
Your washer has a suds build-up. Too much detergent may have been used for the
amount of soft in the load.
Wait for suds to dissolve (about 20 minutes).
Rinse clothing using the RINSE and SPiN cycle, or run through another cycle.
Checkthat the lid is closed.
Press START/PAUSE
Center.
Single beep every second and ...
3. Check your washer is level (refer to installation instructions pages 6 - 11).
4. Remove load and retry.
5. Put through a RINSE and SPIN cycle.
6. if the fault re-occurs repeat steps 1 and 2.
if the washer still will not work, call your Fisher & Paykel Dealer or Authorized Service Agent to
arrange service (refer to page 45).
Loading ...
Loading ...
Loading ...