Loading ...
Loading ...
Loading ...
10
Utility Sink
Tie Strap
Drain Hose
Elbow
Bracket
INSTALLATION INSTRUCTIONS
CONNECTING THE DRAIN HOSE
Drain Hose Extension
Drain Hose
Elbow
Bracket
Tie Strap
The drain hose should always be properly secured.•
Failure to properly secure the drain hose can result in
flooding and property damage.
Do not install the end of the drain hose lower than 29•
in. (73.7 cm) or higher than 96 in. (243.8 cm) above
the bottom of the washer.
The drain must be installed in accordance with any•
applicable local codes and regulations.
Make sure that the drain hose is not stretched,•
pinched, crushed, or kinked.
NOTE:
A drain hose extension kit is
available if the drain hose is not
long enough. Do not extend the
drain hose more than 6 feet, as
this will cause poor draining,
which will result in poor wash
and spin performance.
Option 1: Standpipe
Install the end of the drain hose into the elbow bracket.
Do not extend the drain hose more than 4 inches
(10 cm) past the end of the elbow bracket. Use a tie
strap to secure the drain hose in place.
NOTE:
Total height of the hose end should not exceed 96•
in. (243.8 cm) from the bottom of the washer.
The drain hose should be inserted no more than•
8-12 inches (20-30 cm) into the standpipe. Inserting
more than 8-12 inches (20-30 cm) can cause mold
or microorganisms to spread to the inside of the
washer.
If the water valves and drain are
built into the wall, fasten the drain
hose to one of the water hoses with
the tie strap.
Tie Strap
Option 2: Laundry Tub
Install the elbow bracket near the end of the drain hose.
Hang the end of the drain hose over the side of the
utility sink. Use a tie strap to secure the drain hose in
place.
CONNECTING TO THE POWER SUPPLY
Washer should be plugged into a 120-VAC, 60-Hz
grounded 3-prong outlet. Plug in the washer.
Loading ...
Loading ...
Loading ...