Loading ...
Loading ...
Loading ...
14 49-2000658 Rev. 0
Installation Instructions
INSTALLING CABINET SUPPORT
INSTALLING ANTI-TIP BRACE
IMPORTANT: When installed below a single or double
oven, check to be sure that any oven supports above
the cutout do not obstruct the 23
1
/2” required depth of
the warming drawer cutout.
■ A 2" minimum clearance between oven and
warming drawer cutouts are required. Additional
clearance may be required if 2 x 4 blocks are used
to support runners or solid floor of the oven above.
■ Thewarmingdrawermaybesupportedbyeithera
solid bottom, 2 x 4 or 2 x 2 runners.
■ Thesupportmustbelevelandrigidlymounted,
flush with the bottom edge of the cutout.
There is no way to level the drawer once it has
been installed. Be sure supports are level.
■ Theentireweightofthedrawerissupportedby
the runners or solid floor and must be capable of
supporting 150 lbs.
WARNING
ANTI-TIP PRECAUTIONS:
The anti-tip brace must be installed to prevent the
drawer from tipping forward when opened and loaded.
Failure to do so could result in personal injury.
INSTALLATION INSTRUCTIONS
2" x 4" or equivalent runners
23
1
/2”23
1
/2”
2" x 4" or equivalent runners
22" 25"
27" 30"
Install 2x4 or 2x2 anti-tip
brace against rear
cabinet wall 9" from floor
to bottom of brace
2x4 or 2x2 runners
or solid bottom
9"
1" = 2.5 cm; 1' = 0.3 m
Loading ...
Loading ...
Loading ...