CCR06BM2PS5 Owner's Manual and Installation Instructions

Loading ...

14 49-1000491 Rev. 4

INSTALLING THE BEVERAGE CENTER (Cont.)

Remove all protective film from the door before

installing the handle.

HANDLE INSTALLATION

1. Remove the handle allen wrench from the

accessory bag located inside the beverage center.

2. Remove the handles from the top piece of the

packaging material.

3. Loosen the set screw using the allen wrench.

Place the handle caps over the fasteners of the

door, so that the Cafe badge is at the top of the

handle. Take care to support the handle so it doesn’t

fall and scratch the appliance finish. Make sure both

handle caps are resting on the face of the door.

4. Lock one end of the handle into position by

tightening the set screw in the handle cap with the

allen wrench provided. DO NOT over-tighten.

.HHSVXSSRUWLQJWKHKDQGOHDV\RXORFNWKHRWKHU

end of the handle into position by tightening the set

screw in the handle cap. DO NOT over-tighten.

LOOSEN

set screw

fastener

handle cap

set screw

Installation Instructions

DOOR ADJUSTMENT

1. Peel back the gasket near the top and bottom hinges.

2. Use a flat screwdriver to remove the plastic cover

near each hinge.

3. Loosen the two screws for the upper hinge and the

two screws for the lower hinge. Adjust the position

and retighten the screws. NOTE: Move the door in

the direction of the arrows to raise the handle side

of the door.

4. Re-install the plastic covers and gasket. Make sure

that the gasket is fully seated in the pocket.

Gasket

INSTALLATION INSTRUCTIONS

Loading ...

Owner's Manual and Installation Instructions - Page 14