Loading ...
Loading ...
Loading ...
23
3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm) of the top
soffit.
NOTE: If an anti-tip board has been used, adjust the leveling legs until
the top of the refrigerator is within ¹⁄₄" (6.35 mm) of the bottom of the
anti-tip board as shown. Do not crush the compressor cover.
A. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
B. Attach to studs with six #8 x 3" (7.6 cm) screws.
C. Compressor cover
D. Distance from bottom of anti-tip board to floor
4.
After leveling the refrigerator, again use a straight edge or 4 ft
level across the front of the refrigerator installation blocks to
the cabinets to check that the refrigerator is still flush.
Install Overlay Series Custom
Panels
IMPORTANT:
� Install the custom handles prior to installing the panels on the
refrigerator. For more information on KitchenAid custom
handle selection, refer to the KitchenAid Catalog, visit www.
kitchenaid.com, or call 1-800-442-9991. In Canada, visit
www.KitchenAid.ca, or call 1-800-807-6777.
� Create custom door overlay panels according to the
specifications in the “Overlay Series Custom Panels” section.
� KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator for service.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer compartment doors.
3. Remove the handle-side and top trims.
A. Trims
4.
Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
A. Panels
5.
Reinstall the handle-side and top trims.
6. Remove the skin from the screw covers. Slide or snap the
screw covers into the handle trim section.
7. Check refrigerator level and alignment. Adjust if needed.
BA
C
2" (5 cm)
D
Loading ...
Loading ...
Loading ...