Loading ...
Loading ...
Loading ...
1. Press the Time Drying button again
and again to set the drying time
value. The display shows 10 minutes.
• The display shows the set time
value: e.g. . Each time you
press this button the time value
increases by 5 minutes.
• After some seconds the display
shows a new time value: e.g. .
The appliance calculates also the
duration of the anti-crease and
the cooling phases.
2. Press the Start/Pause button to start
the programme.
• The display shows regularly a
new time value.
• The drying indicator starts to
flash.
• The display shows the door
locked indicator
.
If you set only 10 minutes of
drying, the appliance
performs only a cooling
phase.
If the laundry is not sufficient
dry, set again a short drying
time.
12.4 End of the drying
programme
The appliance stops automatically.
• The acoustic signals operate.
• In the display
comes on.
• The indicator Start/Pause goes off.
• The last minutes of the drying cycle
the appliance performs a cooling and
anti-crease phase. The door is still
locked.
When the door locked goes off in the
display, you can open the door.
1. Press the On/Off button for some
seconds to deactivate the appliance.
After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew
and odours.
13. FLUFF IN THE FABRICS
During the washing and/or drying phase,
some types of fabric, (sponge, wool,
sweatshirt) could release fluff.
The released fluff could stick to the
fabrics during the next cycle.
This inconvenient increases with
technical fabrics.
To prevent the fluff in your laundry:
• Do not wash dark fabrics after you
washed and dried light coloured
fabrics (hand towel, wool, sweatshirt )
and the contrary.
• Dry this type of fabrics at open air
when they are washed the first time.
• Clean the drain filter.
• After the drying phase, clean the
empty drum, the gasket and the door
with a wet cloth.
To remove the fluff inside the drum,
proceed as follows:
• Empty the drum.
• Clean the drum, the gasket and the
door with a wet cloth.
• Set the rinse programme.
• Simultaneously press the
Temperature and the Dryness Level
buttons until the display shows CLE to
activate the cleaning function.
• Touch the Start/Pause button to start
the programme.
If the appliance is frequently
used, carry out the CLE
programme regularly.
www.aeg.com28
Loading ...
Loading ...
Loading ...