Loading ...
Loading ...
Loading ...
TO ASSEMBLE THE HANDLE
1. Cut tie holding shift rod to lower
handle and move shifter to the neu-
tral position.
2. Loosen, but do not remove, the
screws, flatwashers, Iockwashers,
and hex nuts in the upper holes of
the lower handle. See Figure 3.
3. Remove the fasteners from the low-
er holes of the lower handle See
Figure 3.
Right Hand Side /
Of Upper Handle_
u_ Loosen,
but do not
"_ remove
/11 32,,
Flatwasher
5/16" Hex N
5/16"
5/16" Split _ I_,,,_ _.J
Screw
Lockwasher
Figure 3
NOTE: Make sure the cables are not
caught between the upper and lower
handle.
4. Raise the upper handle into operat-
ing position.
NOTE: If the cables have become dis-
connected form the drive levers, rein-
stall the cables as shown in Figure 4.
Lever
"Z" Fitting _'_
Control Cable Figure 4
5. Install the fasteners that were re-
moved in step 3. DO NOT tighten
until all bolts are in place.
6. Tighten all handle bolts.
F-021073L 8
Loading ...
Loading ...
Loading ...