Loading ...
Loading ...
Loading ...
_,_ad_ IP'_'_Im]V-'_n_U_ j _vj_ln Ii
Auger Drive Belt
If your snow blower will not discharge
snow, check the control cable adjust-
ment. If it is correct, then check the
condition of the auger drive belt. If it is
damaged or loose, replace it (see "How
To Replace The Belts" in this section of
the manual).
1. Disconnect spark plug wire.
2. Remove screw from belt cover.
Remove belt cover (see Figure 36).
3.
4.
5.
Loosen nut on auger idler pulley
and move auger idler pulley towards
belt about 1/8 inch (3 mm) (see
Figure 39).
Tighten nut.
Have someone engage auger drive
clutch. Check tension on belt (op-
posite idler pulley). Belt should de-
flect about 1/2 inch (12.5 mm) with
moderate pressure (Figure 37). You
may have to move idler pulley more
than once to obtain the correct ten-
sion.
Auger
Drive
Engine
Pulley
;,.\O 1/2 inch
----3, _\ (12.5mm)
idler_..._..(/ยข'_ _,_\\ 11"_ Deflection
Pulley L/_ " ",_
Engaged __
Figure 37
6. Reinstall belt cover.
7.
Whenever belts are adjusted or re-
placed, the cables will need to be
adjusted. (See Cable Adjustment in
this section of the manual).
8. Attach the spark plug wire.
HOW TO REPLACE THE BELTS
The drive belts are of special construc-
tion and must be replaced with original
equipment replacement belts available
from your nearest Sears service center.
Some steps require the assistance of a
second person.
How To Remove the Auger Drive Belt
If the auger drive belt is damaged, the
snow thrower will not discharge snow.
Replace the damaged belt as follows.
1. Disconnect the spark plug wire.
2. Loosen the bolts on each side of
the bottom panel (see Figure 38).
3. Remove the bottom panel.
F-021073L 26
Loading ...
Loading ...
Loading ...