Loading ...
Loading ...
Loading ...
[] How to Install the Unit
OUTSIDE FENCE
AWNING
INSIDE
FOAM ...............
COOLED
1/4 Bubble HEAT
RADIATLON
1. To avoid vibration and noise, make sure the unit is installed securely and firmly.
2. Install the unit where the sunlight does not shine directly on the unit.
If the unit r_eives direct sunlight, build an awning to shade the cabinet.
3. There should be no obstacle, like a fence, within 20" which might restrict heat radiation from the
condenser.
4. To prevent reducing performance, install the unit so that louvers of the c_inet are not blocked.
5. Install the unit a little obliquely outward not to avoid leaking the condensed water into the room
(about 1/2" or 1/4 bubble with level).
6. Install the unit with its bottom portion 30~60" above the floor level.
7. Stuff the foam between the top of the unit and the wall to prevent air and insects from getting into
the room.
8. The power cord must be connected to an in,pendent cir_it. The green wire must be grounded.
9. Connect the drain tube to the base pan hole in the rear side if you need to drain (consult a dealer.)
Plastic hose or equivalent may be connected to the drain tube.
[] How to Use the Reversible Inlet Grille(For Some Models)
The grille is designed to clean the filter both upward and downward.
®
(a) (b) (c)
A. Before attaching the front grille to the cabinet, if you want to pull out the
1. Open the inlet grille slightly (a).
2. Turn inside out the front grille (a).
3. Disassemble the inlet grille from the front grille with separating the hinged part by inserting a
straight type screw-driver tip (b).
4. Then, rotate the inlet gdllle 180 degrees and insert the h_ks into bottom holes of the front grille.
5. Insert the filter and attach the front gdlle to the cabinet.
B. If you want to pull out the filter downward;
The grille is already designed that way.
Loading ...
Loading ...
Loading ...