Loading ...
Loading ...
Loading ...
12k, i4k Series Models
[] Remove the Air Conditioner From the Case
1. Remove the 2 shipping screws from the back of
the case.
2, Remove the 2 screws on each side of the case,
Keep these for later use.
Shipping_rews
3. Slide the air conditioner from the case by
gripping the base pan handle and pulling forward
while bracing the case.
4. Before installing the Air Conditioner back into the
case, remove the white styrobam shipping block
from the compressor,
White styroloam bbck
[] SELECT THE BEST LOCATION
2_
3_
To prevent vibration and noise, make
sure the unit is installed securely and
firmly
Install the unit where the sunlight does
not shine directly on the unit.
The outside of the cabinet must extend
outward for at least 12" and there should
be no obstacles, such as a fence or wall,
within 20" from the back of the cabinet
because it will prevent heat radiation of
the condenser.
Restriction of outside air will greatly
reduce the cooling efficiency of the air
conditioner
CAUTION: Al! side louvers of the
cabinet must remain exposed to the
outside of the st_cture.
WINDOW REQUIREMENTS
1 This unit is designed for installation in
standard double hung windows with
actual opening widths from 27" to 39".
The top and bo_om window sash must
open sufficiently to allow a clear vertical
opening of 16" from the bottom of the
upper sash to the window stool.
2. install the unit a little slanted so the back
is slightly lower than the front(about 1/2").
This will force condensed water to flow
to the outside.
3. Install the unit with the bo_om about
30"~60" above the floor level
Heat
radiation
Over 20'
Fence
,-1
\!
'4
"4
-i
,a
\!
27' to 39'
16_'rain
Stroll
1 '
Ilnterior wall
235/8'' min
(Wi_eut frame curtain)
SiN
Exterior
Loading ...
Loading ...
Loading ...