Loading ...
Loading ...
Loading ...
General Care & Cleaning
Removing and Replacing Warmer Drawer
Pullupwithfinger
hmow shlddon r¥
glide. Pullupoll lel_lever
whilepushir_down on
r_ht levee
Pushdown _ finger
Figure I
Figure 2
Oven
Wire •
Holder
To Remove and Replace Warmer (Warm & Ready TM) Drawer
To Remove Warmer Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hex-head screw (see
figure 1). Using a 1/4" socket and ratchet remove the shield.
4. Locate glide lever oneach side of drawer, pull up on the left glide lever and push
down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (see figure 2).
3. Align the glide on each side of the drawer with the glide slots on the range.
4. Push the drawer intothe range untillevers "click" (approximately 2"). Pullthe
drawer open again toseat bearing glides intoposition. Ifyou do not hear the _
levers "click" or the bearing glides do not feel seated remove the drawe r _
and repeat steps 2-4. This will minimize possible damage to the bearing G_
glides. _
F'!v"/'J:t#II_[I Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
Changing the Oven Light
The oven light islocated at the rear ofthe oven and is covered with a glass shield
held by a wire holder. The glass shield must be in place whenever the oven isin
use.
To replace the oven light:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection against possible
broken glass.
Care and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning table for detailed cleaning instructions.
31
Loading ...
Loading ...
Loading ...