Loading ...
Loading ...
Loading ...
5
WARNING
If “growing” bubbles appear do not use or move the gas
cylinder. Contact a gas supplier or your fire
department!
Connecting Regulator to the Gas Cylinder
1.Gas cylinder must be properly secured onto barbecue. (Refer to
assembly section.)
2.Turn all control knobs to the OFF position.
3.Turn gas cylinder OFF by turning hand wheel clockwise to a
full stop.
Gas Cylinder Leak Test
For your safety
• Leak test must be repeated each time gas cylinder is exchanged
or refilled.
• Do not smoke during leak test.
• Do not use an open flame to check for gas leaks.
• Barbecue must be leak tested outdoors in a well-ventilated area,
away from ignition sources such as gas fired or electrical
appliances. During leak test, keep barbecue away from open flames
or sparks.
• Use a clean paintbrush and a 50/50 mild soap and water
solution.
Do not use household cleaning agents. Damage to gas
train components can result.
Brush soapy solution onto areas indicated by arrows
in figure below.
5. Hold regulator and insert nipple into
cylinder valve. Tighten the
coupling nut, holding regulator in a
straight line with gas cylinder
valve so as not to cross-thread the connection.
NOTE:
The connection to
the gas cylinder is an
‘ANTI-CLOCKWISE connection.’
Ensure the connection
is tightened firmly. Normally
only 1-1
1
/
2
threads of the hose
assembly connection should
remain visible.
Direction for
tightening
Leak Testing Valves, Hose and Regulator
1.Turn all barbecue control knobs to OFF.
2.Be sure regulator is tightly connected to gas cylinder.
3.Completely open gas cylinder valve by turning hand wheel
counterclockwise. If you hear a rushing sound, turn gas off
immediately. There is a major leak at the connection. Correct
before proceeding.
4.Brush soapy solution onto areas circled below, or other similar
5.If “growing” bubbles appear, there is a leak. Close gas
cylinder valve immediately and retighten connections. If leaks
cannot be stopped do not try to repair. Call for replacement
parts.
6.Always close gas cylinder valve after performing leak test by
turning hand wheel clockwise.
fittings on your barbecue.
4. Prior to connecting check o ring on regulator nipple
for damage. Replace if damaged.
•
NOTE: Sideburner shelf
fascia and other parts not
shown for clarity.
Loading ...
Loading ...
Loading ...