Loading ...
Loading ...
Loading ...
Installation Instructions
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect it to
the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
l
CAUTION: " /_"
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR
OF CABINET
PLATE
(KITWE1M454)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit
WI:;I M4,54) available from your local service provider.
Place dryer in final location.
,i_WARNING - NEVER LEAVE THE
BACK OPENING WITHOUT THE PLATE.
CHANGING DIRECTION OF
DOOR OPENING
1. Open the door and remove the filler plugs opposite the
hinges. With the door completely open, remove the
bottom screws from each hinge on the dryer face. Insert
these screw's about half way into the TOP holes, for each
hinge on the opposite side (where yon removed the filler
plugs). Apply firm pressure to get the screw started.
2. Loosen the top screws from each hinge on the dryer lace
half way. With one hand holding the top of the door and
the other hand holding the bottom, remove the door
t)om the dryer by lifting it UP and OUT.
3. Rotate the door 180°. Insert the door on the opposite side
of the opening by moving the door IN and DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step t.
4. Remove the remainiug screx_.s fio,n the side of the
ope_ing from which the door was removed. With these
screws secure each hinge at the bc,ttom. Tighten the two
top screws on each hinge. Reinsert ihe plasiic plugs on
the side from which the door was removed.
t.OOSENTHETOP
REMOVETHE SCREWSFROM
BOTTOMSCREW EACHHINGEON
FROMEACHHINGE THEDRYERFACE
ONTHEDRYER HALFWAY,
MOVETHEDOORINAND
DOWNUNTILTHETOPHINGE
ANDTHEBOTTOMHINGEARE
RESTINGONTHETOPSCREWS
INSERTEDINSTEP1.
SECUREEACHHINGE
ATTHEBOTTOMAND
TIGHTENTHETWOTOP
SCREWSOFEACHHINGE.
_7!'{ I } Pt![, # i i[{)
8
',i41SERVICING
,_ WARNING- LABEL ALL WIRES
PRIOR TO DISCONNECTION WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/INSTALLATION.
b',orrepJaccmen_ p:_i:ts and other ii_fornlati_n, refer to
Owi_er's Manna[ i?_l"serx.icing phone nllmbers.
i i i