Loading ...
Loading ...
Loading ...
Installation Instructions
[] SECURE REFRIGERATOR
TO CABINETS
Whenever possible, perform this step for
anti-tip security.
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
• Drive a screw through the trim and into the
adjacent cabinet using holes provided.
• Follow the same procedure on the opposite
side.
Drive Screws
ThroughCaseTrimInt0
Adjacent Cabinets
[] ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door
stop. When space does not allow the door to
swing open fully to 130 °, you may change the
door swing to a 90 ° opening.
SKIP THIS STEP IF DOOR OPENING IS
SATISFACTORY FOR YOUR INSTALLATION
SITUATION.
• Open the door to view the bottom hinge.
Note the door stop pin location. The pin is
factory installed in the 130 ° position.
• Partially close the door. From above, use a
flat-head screwdriver to unscrew the door
stop pin and reinstall into the 90 ° position.
Interior
/,
,/
J/l!
I/if
!/f/
I_ /y °°r
///,
d
_J
Hinge
INSTALL GRILLE PANEL
• Raise the grille panel to the stop position,
4g.
I ° °
_Raise t ==
_Grille_
_Panel _ []
Remove 4 screws on bottom trim; retain
all screws.
Remove bottom trim.
NOTE: Stainless steel and acrylic panels
are covered with a protective film. Remove
the film before installing the panel.
Slide panel over the metal backer panel
and under the trim.
• If necessary, tap with a wood block until
panel slips under the top trim piece.
• Reassemble bottom trim. Tighten screws.
32
Loading ...
Loading ...
Loading ...