Loading ...
Loading ...
Loading ...
Replacingthelightbulbs.
Setting the controls to OFF does not remove power to the light circuit.
Refrigerator Compartment--Upper Light
(appearance may vary)
O Raise the grille panel, set the master
power switch to the 0 (on) position eaK1
allow leanps to cool.
O To remove the light shield, press on the
Left side of the shieM and pull down.
O Replace the bulbs with appliance bulbs
of the saine or lower wattage. Replace
the shield by engaging the bottoin tab
into the slot guld applyh_g light forward
pressure until the shield snaps hi place.
Set the master power switch to the ](on)
position and close the grille pealel.
Refrigerator Compartment--Lower Light
Thislight is located above the top draweL
Raise the grille panel, set the master
power switch to the 0 (off) position and
allow lmnps to cool.
Remove iteins fl'om the shelf above the
light shield. Remove the shelf.
Use both hgu_ds to grasp each end of
the light shield. Press h_ on the bottom
of the shield with your thuInbs while
rotating the cover up guld out.
Replace the bulb with ea_appliealce
bulb of the saine or lower wattage.
Replace the shield by engaging the
bottom tab into the slot and applying
light forward pressure until the shield
snaps hi place.
Set the master power switch to the ](on)
position and close the grille panel.
Freezer Compartment
Raise the grille pgu_el, set the master
power switch to the 0 (off) position eald
allow lamps to cool.
Remove the iteins fl'oin the shelf just
below the light sh>ld. Reinove the
shelf.
@
To remove the light shield, press clown
on the top of the shield and pull the
tabs out of the slots. Tilt the shield
forward eaKl out.
Replace the bulb with an appliance
bulb of the same or lower wattage,
and reinstall the light shield. Replace
the shield by engaging the bottom tab
into the slot eald applyh_g light forward
pressure until the shield snaps hi place.
Set the master power switch to the ](on)
position and close the grille pealel.
Dispenser
O Raise the grille pgu_el, set the master
power switch to the 0 (off) position eald
allow lamps to cool.
The bulb is located in the dispenser
under the control panel. Remove the
two screws fl'om the light shield. Slide
the light shield toward the dispenser to
disengage the tabs, then remove the
light shield. Remove the light bulb by
turning it counterclockwise.
Replace the bulb with a bulb of the
same size and wattage. Replace the
light shield by sliding the tabs into
the slots in the front of the dispenser.
Replace the two screws.
Set the master power switch to the I(on)
position and close the grille pealel.
14
Loading ...
Loading ...
Loading ...