Loading ...
Loading ...
Loading ...
5.2
ADDITIONAL SAFETY INSTRUCTIONS FOR SUBMERSIBLE WATER PUMPS
- When carrying or lifting the submersible pump always use the transport handle, DO NOT
carry or lift using the power cable or float switch cable.
- Before connecting to the power supply:
• A residual current circuit breaker (RCD) must be used for all applications
(Draper Stock No.69307 or 89301).
• The electrical supply should be the same as that stated on the rating plate.
- Submersible water pumps should always be transported, stored, and submersed vertically.
- Always ensure that your hands are dry when connecting and disconnecting the
power supply.
- Never operate the pump below the top of the water inlet.
- The area being pumped should be kept clear, and nobody should enter the area while pump is
operating.
- Do not pump explosive or flammable liquids.
Important: please read before use.
The following additional instructions must be followed at all times. Failure to do so could
invalidate the guarantee of this submersible water pump.
- The float switch must be clamped in position using the cable clamp recess.
NOTE: The pump, should be suspended using a rope, chain or stood on a brick to prevent
any gravel etc. being sucked into the pump and damaging the impeller.
- If the pump fails to operate, disconnect from mains supply. Remove the base and gently turn
the impeller using a screwdriver. Check for obstruction in the impeller, i.e. stones/gravel etc.
- The float switch fitted to the pump is NOT suitable for continuous use as an ON/OFF switch.
- If the power cable becomes damaged it must be changed by the manufacturer or it’s service
agents.
IMPORTANT: Any pump returned to Draper Tools Limited under warranty must be clean. If a pump
is received that has NOT been cleaned, it will be returned to you at your cost.
Make sure the power supply information on the machine’s rating plate are compatible with the
power supply you intend to connect it to.
THE FOLLOWING ADDITIONAL INSTRUCTIONS MUST BE FOLLOWED AT ALL TIMES.
FAILURE TO DO SO COULD INVALIDATE THE GUARANTEE OF THIS SUBMERSIBLE WATER
PUMP.
1. The float switch must be clamped in position using cable clamp recess.
2. Clean water pumps are not suitable for use in dirty water.
3. These water pumps are designed for pumping water only.
The addition of any chemicals, chlorine or additives to the water could damage the pump, this
would be considered misuse and would not be covered under warranty.
4. When using clean water pumps in a pond or where there is gravel, mud, leaves, etc.
NOTE: The pump, should be suspended using a rope or chain or stood on a brick to prevent
any gravel, etc., being sucked into the pump.
5. If the pump fails to operate, disconnect from mains supply. Remove output elbow and turn the
impeller using a screwdriver or finger. Check for obstruction in the impeller, i.e. stones/gravel,
etc.
6. The float switch fitted to this pump is not suitable for continuous use as an on/off switch.
IMPORTANT: ANY PUMP RETURNED TO DRAPER TOOLS UNDER WARRANTY MUST BE
CLEAN. IF A PUMP IS RECEIVED THAT IS NOT, OR HAS NOT BEEN CLEANED, IT WILL BE
RETURNED TO YOU AT YOUR COST.
5. HEALTH AND SAFETY INFORMATION
- 8 -
Loading ...
Loading ...
Loading ...