Loading ...
Loading ...
Loading ...
9. INSTALLING THE PUMP
9.3 SET CUT OFF FLOAT HEIGHT
FIG. 7
The float switch can be set to a specific cut off
level by increasing or decreasing the length of
cable % between the cable clamp recess
& and float switch .
9.4 SET INTEGRAL FLOAT HEIGHT FIG. 8 (Stock No. 98917& 98918 only)
An integral float switch is fitted to the pump,
this enables the pump to switch off
automatically when the water has reached
the minimum level. To enable the float
switch ensure the mode selection lever is
pushed down to Auto.
As the water level drops the float switch will
fall with the water level. The minimum level
can be changed by pinching the levers
together and raise or lower to desired level.
When the float switch reaches the minimum
level it will automatically switch the pump
off.
This pump can also be run in a continuous
mode by pulling the mode selection lever up
so it indicates on the side of the pump
Manual. The pump should not be left
unattended at any time, to ensure the pump
does not run dry.
%
&
FIG.7
FIG.8
Stock No. 98917 shown.
- 15 -
Loading ...
Loading ...
Loading ...