Loading ...
Loading ...
Loading ...
SECTION2: ASSEMBLINGYOURSNOWTHROWER
UnpackingFromCarton
• Cut along corners of the carton and lay it down flat.
Remove packing material.
• Remove any loose parts included with unit (i.e.,
operator's manual, etc.).
• Roll unit out of carton. Check carton thoroughly for
any remaining loose part.
ItemsRequiredForAssembly
1. Pair of pliers
2. Engine oil
3. Fresh gasoline
NOTE: All references to left or right side of the snow
thrower is from the operating position only.
BeforeAssembly
WARNING: Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting. See Figure 1.
RaisingUpperHandle
• Loosen the hand knob on each side of the handle.
Remove packing material, if any.
Hand Knob
d Knob
Spark Plug
Access
Figure 1
• Raise the upper handle inthe direction shown in
Figure 1 until it clicks into the operating position.
Make sure not to pinch or crimp the cable.
• Tighten the hand knobs.
AttachingChuteCrank
The lower chute crank is already attached to your snow
thrower at the factory. For shipping purposes, the upper
chute crank is packaged as loose part. Attach itto the
lower chute crank following instructions:
• Remove the hairpin clip from the end of the lower
chute crank.
• Insert the upper chute crank into the lower chute
crank and align the holes.
• Re-insert the hairpin clip into the hole to secure the
two chute cranks. See Figure 2.
_IOTE: For danty
of viewing, the
control handle is
removed from the
p_oture. DO not
remove it for the task..
Figure 2
AttachingControlCable
The control cable may already be attached to the
control handle. If not attached, complete the following
steps to attach it to the snow thrower housing.
• Route the control cable over the lower handle.
Insert the end of the cable into the hole in the
control housing as shown in Figure 3. Push the
plastic fitting until it locks into the control housing.
End _1
Hole of Cable
Control
Handle
Housing
Fitting
Figure 3
Lift the control handle up, and hook the "Z" end of
the control cable into the bottom hole in the control
handle, from the outside to the inside. If necessary,
pull up on the end of the cable with a pair of pliers to
obtain slack in order to hook it into the control
Loading ...
Loading ...
Loading ...