Loading ...
Loading ...
Loading ...
SECTION8: TROUBLESHOOTINGGUIDE
Problem Cause
Engine fails to start 1. Fuel tank empty, or stale fuel
2. Blocked fuel line
3. Key not in ON position
4. Spark plug wire disconnected
5. Faulty spark plug
6. Engine not primed
7. Engine flooded with excessive priming
Engine runs erratic 1. Unit running on choke 1.
2. Fuel line blocked, or stale fuel 2.
3. Water or dirt in fuel system 3.
4. Carburetor out of adjustment 4.
Engine overheats 1. Carburetor out of adjustment 1.
Loss of power 1. Spark plug wire loose 1.
2. Vent in gas cap plugged 2.
Excessive vibration 1. Loose parts or damaged auger 1.
Unit fails to self- 1. Drive cable out of adjustment 1.
propel
2. Drive belt loose or damaged 2.
Unit fails to 1. Discharge chute clogged 1.
discharge snow
2. Foreign object lodged in auger
3. Drive cable not adjusted properly
4. Drive belt loose or damaged
Remedy
1. Fill tank with clean fresh gasoline.
2. Clean fuel line
3. Insert key and turn to ON position
4. Connect wire to spark plug.
5. Clean spark plug, readjust gap, or
replace.
6. Prime engine four times.
7. Wait at least ten minutes before
starting.
Move choke lever to OFF position.
Clean fuel line and fill tank with fresh,
clean gasoline.
Refer to engine manual for remedy.
Refer to engine manual for remedy.
Refer to engine manual for instruction.
Connect and tighten spark plug wire.
Clear vent.
Stop engine immediately and
disconnect spark plug wire. Check for
possible damage. Tighten all bolts
and nuts. Repair as needed. If the
problem persists, take unit to an
authorized service dealer.
Adjust drive cable following
instructions on page 9 of this manual.
Replace drive cable.
Stop engine immediately and
disconnect spark plug wire. Clean
discharge chute and the auger
housing.
2. Stop engine immediately and
disconnect spark plug wire. Remove
object.
3. Adjust drive cable following
instructions on page 9 of this manual.
4. Replace drive belt.
NOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized service
representative or call 1-866-840-6483 for the Customer Support Center. Refer to the engine manual for more
engine related information.
11
Loading ...
Loading ...
Loading ...