Loading ...
Loading ...
Loading ...
Water fi te
All the water to your fridge is filtered to remove impurities through a cartridge located in a
position of your choice outside the refrigerator. Of course, this will need changing approximately
every 6 months or up to 2800 L depending on the quality of the incoming water and how much
you use the dispenser.
There is a replacement indicator Q icon on the control panel which will appear when the filter
needs replacing. It will flash, when dispensing water, as a reminder.
Rephcement cartridges are available from your authorised Fisher and Paykd Dealer.The details
of the replacement cartridge are on the label on the cartridge.
Changing the water filter cartridge
1 Grasp and firmly twist the cartridge in an anticJockwise direction (to the left when installed in
the recommended orientation) as shown in Diagram 1.
2 Pull the cartridge away from the filter head (down when installed in the recommended
orientation) as shown in Diagram 2.
- It is not unusual for a few drops of water to be present when filter is removed.
3 Discard old filter.
4 Filter installation:
- Remove protective cap on spigot on head.
- Push the cartridge up towards filter head while rotating it in a clockwise direction (to the right
when installed in the recommended orientation) as shown in Diagram 3.
5 Reset filter indicator icon on the display (this will set to remind you when the filter is due to be
replaced again). Refer to page 19.
6 Dispense 5 L / 5 qt to flush the cartridge, removing trapped air and harmless carbon fines.
7 A few drips may appear out of the dispenser over the next few days as the remaining trapped air
is cleared.
Diagram 1 Diagram 3
Fig. 18 Chonging the woter filter cartridge
Loading ...
Loading ...
Loading ...