Loading ...
Loading ...
Loading ...
STEP 13 - ATTACH BAG BOTTOM
, insert the bag frame strap into the stitched sleeve at
the front edge of the bag bottom, See figure 11,
Fold the bag flaps around the lower hopper tubes and
attach to the bag bottom using the snaps, See figure
13,
BAG FRAME STRAP
STITCHED
SLEEVE
SNAP
FIGURE 11
FIGURE 13
Assemble the bag frame strap to the holes in the
lower hopper tubes using two clevis pins (N) and hair
cotter pins (L), See figure 12,
BAG FRAME STRAP
STEP 14 - ASSEMBLE SUPPORT RODS
IMPORTANT: Do not over bend the support rods
during the following step, Over bending wil! decrease the
supporting tension of the rods,
Assemble the two hopper support rods as shown in
figure 14, Place the ends of the rods into the holes in
the upper and lower hopper tubes, flexing the rod just
enough to fit into the holes in the tubes,
NOTE: The hopper's mesh wind screen is not shown in
figure 14 in order to better show the hopper support
rods,
CLEVIS PiN [NI
\
FIGURE 12
FIGURE 14
Loading ...
Loading ...
Loading ...