Loading ...
Loading ...
Loading ...
SANTOS: User and maintenance manual
98163 EN 1.1 - 04 2018 12 / 19 www.santos.fr
FAULT FINDING
Carefully determine the reason for the appliance stopping.
In all cases: If the problem persists, switch off the power supply to the machine
(unplug the cord from the mains socket) and call in the maintenance service or
contact a SANTOS approved dealer.
The machine will not start:
• Check: the mains power supply and the condition of the power supply cord,
• The main switch (8) should be in position "1"
• Press the thermal circuit breaker (9) once.
• Note: the On/Off push button (10) must be lit up in the "pressed" position.
• Check that there is no foreign body stuck between the grinding-discs.
• Check the electric components, replacing them one by one
The appliance stops after the motor has overheated:
(the metal casing around the motor unit is hot)
In the event of the motor overheating, the appliance stops automatically.
The cutout built-in to the motor is reset automatically. Wait until the motor cools down (15 to
30 minutes) before starting the machine back up.
The appliance stops following an overload:
Should the motor become blocked (foreign body, object that is too hard), the overload
cutout (9) at the rear of the appliance triggers automatically and cuts out the power supply
to the appliance
• Deactivate the On/Off push button (10)
• Put the main switch (8) to position "0" and unplug the appliance.
• Correct the fault and actuate the button of the overload cutout (9)
If the problem persists, check the following points:
• Check that the grinding-discs are not touching one another.
• Check for wear on the grinding-discs (too fine a grind with worn grinding-discs may
result in a motor overload).
Loading ...
Loading ...
Loading ...