Loading ...
Loading ...
Loading ...
SANTOS: User and maintenance manual
98163 EN 1.1 - 04 2018 11 / 19 www.santos.fr
5
6
4
7
7
4
Fig. J
Fig. I
1. Unlocking the graduated ring:
• Unscrew the locking screw (5) of the graduated ring
• Turn the grind adjusting button (6) 2 tours anticlockwise.
2. Clean the grinder body and the top plate (19).
3. Position the top plate (19) aligning the guide of the shutter (3) with the opening above
the adjusting button.
4. Fix the top plate (19), then the coffee shutter (3).
5. Fit the hopper (3) and fix the 4 fixing screws (15) (16).
6. Fit the magnetic identification plate (14).
7. Do the zero setting of the graduated ring.
ZERO ADJUSTMENT OF GRADUATED RING
This should be done after replacing the grinding-discs.
1. Plug the appliance in and run it empty.
2. Unscrew the locking screw (5) of the graduated ring (4).
Check that the ring (4) turns freely without driving the
adjusting button (6) (fig. J)
3. Turn button (6) clockwise until the grinding-discs come
into contact (a slight rubbing noise can be heard) then
turn slightly in the opposite direction so that they are no
longer touching one another. (fig. J)
BE CAREFUL
This is a delicate operation and prolonged contact
between the grinding-discs should be avoided as this
could damage them.
4. Stop the machine by pressing the On/Off button (10).
5. Without moving button (6), align the "0" of the graduated ring
(4) with the red index mark (7) (ring at end position), then
tighten the locking screw (5) without moving the graduated
button or the adjusting button. (fig. I)
6. Run the machine empty in the finest grind position ("0"), to
check that the grinding-discs rotate without touching other. If
this is not the case, repeat the above procedure.
!
Loading ...
Loading ...
Loading ...