Loading ...
Loading ...
Loading ...
Keep Warm Function
The Keep Warm Function can be used to keep food warm for long periods of time (up to 2 hours). The
cookware can be removed from the element for up to 10 minutes without disabling the function.
1. The appliance must be set to Operating-Mode.
2. Select one of the cooking zones. Press the Keep Warm Function Touch Control (03) and the Cooking
Zone Select touch control & Power LED display of the selected cooking zone will change to “U”.
3. The function can be disabled by adjusting the cooking zone power level.
Stop N Go Function
The Stop N Go Function allows you to stop all activity on the appliance (cooking, timers) and restart for where
you left off at a later time.
1. While the appliance is in Operating-Mode, press the Stop N Go/Recall Function
Touch Control (02). A
pause symbol “ll” will appear in each Cooking Zone Select touch control & Power LED display and the
indicator above the sensor will light up. All functions will pause, and all touch sensors disabled (except for
On/Off Power touch control).
2. Once ready to restart, press the Stop N Go/Recall Function
Touch Control (02) again. The indicator
above the sensor will flash for 2 seconds. Press any other touch sensor within that 2 seconds and the
pause symbols will disappear. The appliance will then continue to work as it was before.
Recall Function
There may be times when you are cooking and press the On/Off Power touch control by mistake, deleting all
functions and timers. If the On/Off Power touch control is pressed again (within 6 seconds of the appliance
being set to Stand-By-Mode), the indicator above the Stop N Go/Recall Function
Touch Control (02) will flash
for 5 seconds. Press the Stop N Go/Recall Function
Touch Control while it’s flashing, and the previous
settings for the appliance will be recalled.
TOUCH CONTROL SAFETY FUNCTIONS
The following safety functions are available to avoid unintended operations of the cooktop control:
Pan Detection Failure
If a cooking zone is activated and undersized cookware, incorrect material cookware or no cookware is
detected, the symbol U will be displayed on the cooking zone LED display and the cooking zone will be
disabled. Place or replace cookware on the cooking zone.
Residual Heat Functions
After all cooking processes there is some heat stored in the glass top called residual heat. The control can
calculate roughly how hot the glass is in the worst case. If the calculated temperature is higher than + 60 ° C,
then this will be indicated in the corresponding Cooking Zone Select touch control & Power LED display with
a red “H” after the cooktop has turned off. The residual heat display is shown as long as the calculated
cooking zone temperature is > + 60 ° C.
7
Loading ...
Loading ...
Loading ...