Loading ...
Loading ...
Loading ...
27
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
Completing the move
Unfold the rear edge of the cardboard base tray. Open the
oven door(s) so that you can get a good grip on the bottom
of the fascia panel as you move the oven (Fig. 9.6).
Carefully push the range backwards o the base tray. Remove
the base tray.
Position the range close to its nal position, leaving just
enough space to get behind it (Fig. 9.7).
n
DO NOT use the door handles or control knobs to
manoeuvre the range.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the range in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units.
The front feet and rear rollers can be adjusted to level the
range. To adjust the height of the rear of the range turn the
adjusting nuts at the front bottom corners of the range. To set
the front feet turn the bases to raise or lower.
Fitting a Stability Bracket
When tting a stability bracket (Fig. 9.8) please refer to the
instructions supplied with the bracket for further details on
tting.
When tting a stability bracket (Fig. 9.9 and Fig. 9.10)
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Fitting the Restraining Chain
The restraining chain MUST be tted.
The length of chain between the appliance and the wall xing
should prevent strain on the gas and electricity connections,
but still allow access to unhook the chain when the cooker is
pull forward.
Measure the length of chain required. Use the clamp supplied
to clamp onto the gas pipe (Fig. 9.11). Fix the supplied hook
securely to the wall.
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability
bracket
Floor
Stability
location
bracket
Wall
Typical wall mounting
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
Stability
location
bracket
Typical floor mounting
Alternative positions
for stability location
bracket
ArtNo.010-0004 Moving the cooker
Fig. 9.6
Fig. 9.7
Fig. 9.8
Fig. 9.9
Fig. 9.10
Fig. 9.11
ArtNo.011-0007 - Restraining chain (AUS)
Restraining
chain
Caution, possibility of tilting
Anti-tip restraints
Loading ...
Loading ...
Loading ...