Loading ...
Loading ...
Loading ...
SETTING UP YOUR STOVE
Before you light your stove for the first time, please follow these instructions.
1) Install the bottom heat shield, 2) Attach coiled spring handle for the top lid, 3) Attach the knob for the bypass handle
(1)How to attach the Fireview bottom heat shield:
The bottom heat shield prevents excess heat from being radiated from the base of the stove onto the hearth. The bottom
heat shield also contains a pocket to hold the Fall-Away Handle.
1. Attach the “V-Shaped” pocket to the bottom of the heat shield. Hardware is included with the manual and the 4
holes are pre-drilled. This pocket serves as storage for the Fall-Away Handle.
2. There are 4 threaded posts behind each of the four stove legs. Slide the shield
under the stove and attach it through the leg bolts with the 4 nuts provided in
the manual package. The shield hangs down below the bottom of the stove, and
rests on the nut, leaving air space for cooling.
3. The “V-Shaped” pocket will be on the bottom of the heat shield, right under
loading door. Slide the Fall-Away Handle into the V-pocket for easy storage.
(2) Attaching the Coiled Spring Handle:
Widen the end of the loop in the coiled spring handle, and slide the end of the loop down
through the hole at the front of the top casting. To eliminate the possibility of the handle
coming off while raising or lowering the lid, the end of the coiled spring handle should be
squeezed shut after it is attached to the lid. Wrap a soft cloth around the handle to protect the
plated finish, and squeeze the handle shut with a pair of pliers.
NOTE: When you raise or lower the lid, be sure the coiled spring handle is above the lid;
don’t use the handle to push the lid up or lower it down (see illustration).
(3) How to Attach the Fireview Bypass Damper Knob:
The Fireview Bypass Damper is pre-installed. Attach the “press-on” black plastic knob on
the end of the bypass rod at the back of the stove using a pushing, twisting motion; or gently
hammer the knob onto the rod with a soft mallet.
Lift the top lid by pulling up
on the coil spring handle.
Do not push the lid up using
the handle (the handle might
slip off the top lid).
Installation of Fireview bottom heat shield and
V-pocket. The Fall Away Handle slides into the
V-pocket, as shown above.
Loading ...
Loading ...
Loading ...