Loading ...
Loading ...
Loading ...
WARNING!
●
This product is heavy and requires two persons for installation.
●
Installation work and electrical wiring must be done by qualified person(s)
●
Failure to install the screws or fixing device in accordance with these instructions
IMPORTANT!
Wear gloves to protect against sharp edges.
Installation
1
Preparing for installation:
Before installing your rangehood:
●
Please read the instructions carefully.
●
Unpack the rangehood.
●
Ensure that the voltage (V) and the frequency (Hz) indicated on the serial plate
match the voltage and frequency at the installation site.
●
Check that all functions are working.
●
Check that the area behind the installation surface to be drilled is clear of any
electrical cables or pipes, etc.
●
The rangehood surfaces can be damaged during installation if grazed or knocked
by tools. Please take care to protect the surfaces during installation.
●
Protect the cooktop surface with cardboard, or the like, to prevent damage occurring
whilst the rangehood is being installed above.
●
Temporarily mark the height of the bottom of the rangehood and the centre of the
cooktop on the wall according to the information given in the ‘Installation instructions
– Height of rangehood’ section.
●
The wall used for mounting the rangehood should have sufficient strength and a
flat surface.
2
Attach chimney brackets and rangehood mounting screws to the wall
There are two methods of installation possible. One uses the supplied bracket. The
other method attaches the rangehood to screws directly.
• Attach the Inside chimney bracket and the Hood mounting bracket in the
locations shown in . Use ST4*40mm screws.
• OR Attach the Inside chimney bracket and the two mounting screws in the
locations shown in
2
. Use ST4*40mm screws. Ensure that there is a 2-5mm
gap between the screw head and the wall. See
Use the wall plugs if required.
10
Ensure there is a power socket accessible behind the chimney.
2-5mm
1
3
Pic 1
pic
.
pic
pic
Loading ...
Loading ...
Loading ...