Loading ...
Loading ...
Loading ...
02 OPERATING01 SETTING UP
Setting up _7
Allow clearance to the right, left, back and
top when installing.
This will help reduce power consumption and
keep your energy bills lower.
Do not install the Refrigerator where the
temperature will go below 50 ºF (10 ºC).
When moving your refrigerator
To prevent fl oor damage be sure the front leveling
legs are in the up position(above the fl oor).
Refer to ‘ADJUSTING THE DOORS’ in the manual
(at page 9)
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that is the
same height as the rest of the fl ooring. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 660 lbs (299 kg).
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place under
the refrigerator where you are working. When
moving, be sure to pull the unit straight out and
push back in straight.
REMOVING THE REFRIGERATOR
DOORS
If the Refrigerator is too large to pass through your
doorway easily, you can remove the refrigerator
doors.
Tools you will need(Not provided)
Disconnect power to the refrigerator
before removing the door or drawer.
Be careful not to drop, damage or scratch
the door/drawer while removing them.
Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the Refrigerator doors
1. With the door opened, remove the Hinge Cover
cap
1
with a Flat head screwdriver, and close
the door. Remove the 3 screws holding down
the Hinge Cover and remove the Hinge Cover
2
.
2. Disconnect two connectors
3
at each side
of the top cap, the one connector
7
on right
side door and the other connector
4
on left
side door. Remove the tube
5
with pressing
the dark gray color part
6
of the water line
coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
1088mm
614mm462mm
1174mm
2
1
Philips
screwdriver
Flat-blade
screwdriver
Wrench(10 mm)
Pliers
Allen wrench
(3/16”) (5 mm)
WARNING
5
6
4
3
3
4
7
Red Clip
(1/4")
DA99-03403A(0.5).indd Sec4:7DA99-03403A(0.5).indd Sec4:7 2012.5.25 1:27:23 PM2012.5.25 1:27:23 PM
Loading ...
Loading ...
Loading ...