Loading ...
Loading ...
Loading ...
HANDLEBAR
|
#51.5/16"x 5/8"
Hex Head Bolt (2 pcs)
#72.5/16"x 18ram x 1.ST
FlatWasher (2 pcs)
#10:3.5/16"x 1.ST
Split Washer (2 pcs)
1. Remove the plastic tie from the center of the handlebar (:3).Insert the two
hand pulse cables (:26) through the opening of the handlebar mounting
bracket on the front side of the console mast tube (2). Pull the cables through
the opening of the console mounting bracket at the rear of the console mast
tube
2. Attach the Handle Bar (3) to the Front Console Mast (:2)with the two Hex
Head bolts (51), two Flat Washers (7:2) and two Split Washers (103).Tighten
using the 12/14mm Wrench (100). Be careful not to pinch the cables when
fastening.
PLASTIC '
Seepage 8 for illustration
1. Insert the Computer Cable (29) and two Hand pulse cables (:26) into the
connectors in the back of the Console (34).
2. Attach the Console (34) onto the Console Mast (2) with four Phillips Head
Screws (58). Be careful not to pinch the cables when fastening.
3. Attach the Front Stabilizer Cover (40) to the Main Frame (1) with two Phillips
Head Screws (S8).Tighten with the Phillips Head Screw Driver (93).
4. Install the Pedals (45 L,46 R)onto the Cranks by using the 13/15mm Wrench
(92). Remember that the left pedal has a reverse thread and will be screwed
into the crank in the opposite rotation from normal threads. There is an L
stamped into the end of the threaded post of the left pedal and an Ron the
end of the right post. Make sure to tighten the pedals as much asyou
possibly can. It may be necessary to re-tighten the pedals if you feel a
thumping while pedaling the bike. A clicking noise or thumping feeling is
usually caused by loose pedals.
5. Install the Seat mount slide (7) onto the track on top of the seat tube with the
seat post facing forward. Place the nut plate (8) onto the seat slide behind the
seat post. Place the fiat washer (71) onto the fore/aft adjustment knob (86)
and thread it into the nut plate from underneath the seat tube track. Attach
the seat (19) to the seat post using the 12/14mm Wrench (100).
/ •
#58. M5 x 12rnm Phillips
Head Screw(6 pcs)
7 B94/R92 FITNESS BIKE
Loading ...
Loading ...
Loading ...