Loading ...
Loading ...
Loading ...
SEAT/PEDAL&PLASTICPARTS
#98. M6 x 15ram Phillips
Head Screw(4 pcs)
#99. M5 x 12mm Phillips
Head Screw(8 pcs)
#105. D4 x 16ram Sheet
Metal Screw (4 pcs)
1. Install the Seat (61) on the Seat Carriage (4) with the four Phillips Head Screws
(98) using the Phillips Head Screw Driver (114).
2. Install the Front Stabilizer Cover (32) and the Rear Stabilizer Cover (37) on the
Main Frame (1) with four Phillips Head Screws (99) using the Phillips Head
Screw Driver(114).
3. Plug in the Computer Cable (44) and Hand pulse Cable (45) into the connector
in the back of the Console Assembly (19). Install the console onto the
mounting plate with four Phillips Head Screws (99) using the Phillips Head
Screw Driver (114). Be careful not to pinch the cables between the console and
the mounting plate. This could short the cables and damage the electronics.
4. Install the Drink Bottle Holders (39 L, 38 R)onto left and right sides of the
Seat Handle Bar (6) with four Sheet Metal Screws (105) using the Phillips Head
Screw Driver(114).
5. Install the Pedals (l16 L, 117 R)in the Pedal Cranks using the14/15mm
Wrench (132). Keep in mind that the Pedal (116 L) has a reverse thread and
will be screwed into the crank in the opposite rotational pattern right hand
threads. There is an "L" stamped into the end of the threaded post of the left
pedal and an "R" in the right. Make sure to tighten the pedals as firmly as you
possibly can. It may be necessary to re-tighten the pedals if you notice a
thumping sound when pedaling the bike. A clicking noise, or thumping sound
during pedaling is usually caused by the pedals being loose.
B94/R92 FITNESS BIKE 14
Loading ...
Loading ...
Loading ...