Loading ...
Loading ...
Loading ...
PAGE: 5 / 12 PAGE: 6 / 12
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS (continued)
1. ATTACH THE FAN BLADES
NOTE: All set screws must be checked and retightened where necessary,
before and after installation.
2. MOUNTING
DOWNROD MOUNT
a.
b.
c.
e.
- Take out fan motor housing.
- Separate mounting bracket from Canopy by removing 4 screws (if shipped assembled),
save screws for installation.
- Remove cotter pin, washer and bolt from yoke as shown in figure (a.).
- Loosen jam screws in yoke until it is flush with the inside surface.
- Obtain downrod, canopy and yoke cover.
- Place downrod through canopy and yoke cover.
- Route wires exiting motor through yoke cover, canopy and downrod, and screw downrod into
yoke as shown below in figure (d.).
- Insert bolt through hole in shaft and downrod. Be careful not to damage or cut the fan wires.
- Add washer and secure with cotter pin as shown in figure (a.). Secure with cotter pin
through hole in the end of the bolt.
- Secure downrod in position by tightening jam screws. Slide yoke cover down so it is flush
with the motor housing.
A
Motor
Yoke
Jam
Screw
Jam
Screw
Downrod
Canopy
Yoke
Cover
Bolt
Flat
Washer
Cotter Pin
Yoke
Jam
Screw
d.
Bolt
Cotter
Flat
Washer
Pin
- Attach the blades to the fan motor assembly using the screws and flat washers.
a.
Fiber Washer
Metal Washer
Blade
Bracket Screw
Blade
Blade Bracket
- Remove the 4 Light Kit screws from fan switch housing.
- Connect polarized connectors of Light Kit to corresponding connectors
found in fan switch housing.
- Align holes in base of light kit (below side chain bushings) with chains
exiting switch housing and route through as shown.
- Install Light Kit with 4 screws previously removed and tighten.
- Attach supplied decorative chain extensions.
Chain
Light Kit
Black or
Blue Wires
Red or Blue
Wires
White Wires
Light Kit Screw
b.
Loading ...
Loading ...
Loading ...