Loading ...
Loading ...
Loading ...
B
- Place two screws and washers on mounting plate (marked B on diagram) which
correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to screws (marked B on diagram)
then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram) then tighten
the two screws (marked B on diagram).
5. MOUNTING FAN ASSEMBLY
NOTE: Once wires are connected, carefully tuck wires and wire nuts into the
outlet box making sure that the wires are clear of the hemisphere
and downrod when positioned in mounting bracket
(Downrod Mount Only).
- Connect white wire from outlet box to white
wire from fan using wire nut (not supplied).
- Connect black wire from outlet box to black
wire from fan plus (red or blue wire) using
a wire nut.
NOTE: A r
ed or blue wire would be power
for a light kit if applicable.
CONNECTING BLACK,WHITE AND (RED OR BLUE) WIRES
Black Wire
White Wire
Red or Blue
Wire
PAGE: 9 / 12 PAGE: 10 / 12
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS (continued) ASSEMBLY INSTRUCTIONS (continued)
6. ENGAGE HEMISPHERE (Downrod Mount Only)
- Carefully rotate fan assembly until groove in hemisphere locks over tab of canopy assembly.
WARNING: Failure to seat tab in groove could cause damage to electrical wires and
possible shock or fire hazard.
Downrod
Hemisphere
Groove
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket faces towards
the top of the slope. Depending on the slope, a longer downrod may be required to prevent
fan blades from hitting the ceiling.
7. LIGHT KIT
WARNING: Ensure that all connections, set screws and screws are securely tightened
before the next step.
WARNING: BE SURE TO TURN OFF POWER BEFORE INSTALLING
a.
b.
- Install supplied led lamps.
- Secure the glass cover to the light kit as shown in diagram below.
(A)
(B)
(B)
Washers
(A)
Bulb
Glass
Light Kit
Motor
Loading ...
Loading ...