Loading ...
Loading ...
Loading ...
To Light the Burner
Lighting Procedure - SEE FIG 5 - 11
1. The main burner gas flow is set with the ‘oven
thermostat knob’ (See Fig. 5). First ensure both
knobs are turned fully clockwise. Gas control knob to
the OFF position thermostat and knob to the
minimum setting (thin end of white band).
2. Turn ‘ON/OFF’ gas control knob slightly anti-
clockwise towards the ignition position ( ) until
reaching stop, press down and hold for 5 seconds.
(See Fig. 7).
3. Continue pressing down knob while turning
further anti-clockwise to the ( ) position (See Fig.
8) (this activates the spark ignitor) continue to hold
down for 10 seconds after flame supervision burner
has been lit. (If the it does not light, steps 2 and 3
can be repeated, this can be viewed through the
viewing window.
4. Upon lighting, release knob and turn further anti-
clockwise to the ( ) symbol (See Fig. 9). Main
burner gas flows according to the thermostat setting.
5. Turn the oven thermostat knob slightly anti-clockwise
into the white band (LOW FIRE position) (See Fig.
10). Leave in the low fire position for at least 30
minutes.
NOTE: Low fire position is attained by turning oven gas
control knob gradually into the white band until small
flame is observed through viewing window.
6. After 30 minutes rotate control knob anti-clockwise to
the mid-position of the green band for normal running
(See Fig. 11).
NOTE: After several hours the heat indicator should
show green (See Fig. 1). It maybe necessary to adjust
the control knob in the green band to achieve this.
When the range is lit from cold, moisture may form on
the enamel which should be wiped off to prevent
staining.
IF THE FLAME HAS EXTINGUISHED FOR ANY
REASON, WAIT THREE MINUTES (MINIMUM)
BEFORE RE-LIGHTING.
To Extinguish the Burner
1. Turn ON/OFF gas control knob clockwise until
reaching stop ( ) position.
2. Press down slightly and continue turning clockwise
from ( ) position to the OFF position (See Fig. 6)
When the burner has cooled sufficiently, lighting
procedure may be repeated.
Power Failure
In the event of power failure your appliance will not work.
When the power is restored it will automatically restart.
Burner Controls
18
Hotplates control knob
Oven
thermostat
knob
Oven heat
indicator
Oven gas
control knob
Fig. 5
Viewing
window
Loading ...
Loading ...
Loading ...