Loading ...
Loading ...
Loading ...
D
3.25
F
G
H
3.24
Low suction or pick up may be due to a blockage in
the system. Refer to the following steps to check for
blockages continuing with each step until the block-
age is found:
1. Check fullness of filter bag; change if needed.
Checking Airflow Path
3.23
2. Plug cleaner in and turn ON. Check for suction
at end of hose (A).
a. If there is suction, continue with step 3.
b. If there is no suction, check for blockage in
hose and dirt tube as follows:
1) Disconnect hose from dirt duct (C) by
reversing procedure for “Attach hose”
on p. 4, Figs. 1.5 and 1.6.
2) Clear out hose.
3) Look into (C) and remove blockage.
3. Check connection at hose tube (B); remove any
blockage.
4. Turn cleaner OFF and unplug.
Checking Under Bottom Plate
3.24
5. Remove bottom plate ( Fig. 3.9) and brushroll
(Fig. 3.15).
Look into opening (F), in channnels (G) and around
liner (H), and remove any accumulated debris.
C
B
A
3.23
LUBRICATION
The motor is equipped with bearings that contain
sufficient lubrication for the life of the motor.
The addition of lubricant could cause damage.
Therefore, do not add lubricant to motor
bearings.
16
Actual model may vary from images shown.
WARNING
! !
Agitator brushroll can start suddenly. Unplug
cleaner before turning it over.
CLEARING BLOCKAGES
If Blockage Occurs During Powered
Hand Tool Use
3.25
1. Disconnect powered hand tool from hose.
Remove bottom plate, belt guard and turbine as
described in Figs. 3.19, 3.20 and 3.21.
Remove any blockage from turbine channel (D).
Replace belt turbine, brushroll, belt guard and
bottom plate.
Loading ...
Loading ...
Loading ...