Loading ...
Loading ...
Loading ...
31-2000654 Rev. 3 5
Installation Preparation
INSTALLATION OPTIONS
When installed under a wall oven:
Warming drawers are approved for installation below
only certain specified wall oven models. See the
label attached to the top of the warming drawer for
approved models.
Ŷ:KHQLQVWDOOHGWKHIURQWIDFHRIWKHGUDZHUZLOOEH
nearly flush with adjacent cabinetry doors.
Ŷ'UDZHURYHUODSVZLOOFRQFHDOFXWHGJHVRQDOOVLGHVRI
the opening.
NOTE: Additional clearance between cutouts may be
required. Check to be sure that oven supports above the
Warming Drawer location does not obstruct the required
LQWHULRU´GHSWKDQG´KHLJKW
The rough opening for the drawer must be:
Ŷ'HSWK´PLQIURPLQVLGHEDFNWRIURQWRIFDELQHW
frame.
Ŷ:LGWK´IRU´ZLGHPRGHOV´IRU´
wide models.
Ŷ+HLJKW´
Ŷ$OORZ´PLQEHWZHHQRYHQDQGGUDZHUFXWRXWVIRU
clearance of overlaps.
NOTE: If you are installing in frameless cabinets, it
may be necessary to install 1/2” wide cleats to accept
drawer mounting screws. See drawer for mounting
screw locations.
Installation Below
a Double Oven
[RU[$QWL7LS
Block Against Rear
:DOO´)URP)ORRU
to Bottom of Block
1” Min. Above Toekick
Allow 5/8”
Overlap on
All Sides
´
Min.
Inside
Oven
Cutout
2” Min.
´
A
B
´
´
´
Installation Below
a Single Oven
[RU[$QWL7LS
Block Against Rear
:DOO´)URP)ORRU
to Bottom of Block
1” Min. Above Toekick or Adjust
to Oven Installation Height
´
Min.
Inside
Oven
Cutout
2” Min.
´
A
B
´
´
´
Allow 5/8”
Overlap on
All Sides
Models
Dimensions
A B
=7:6=7:3 ´ ´
=.:6=.:3 ´ ´
Loading ...
Loading ...
Loading ...