Loading ...
Loading ...
Loading ...
IfbladeIS SQUARE to table;
A. Check pointer
If POINTER DOES NOT point to the "O" mark on the
bevel scale;
B. Loosen screw and adjust pointer.., using medium
screwdriver.
If blade is NOT SQUARE to table.., the 90° LIMIT STOP
must be ADJUSTED.
CAUTION: Cover blade with piece of cardboard to protect
your hand.
1. Using a small size screwdriver, reach UNDERNEATH
saw and loosen BOTH setscrews in 90 ° STOP
COLLAR.
NOTE: If you can't reach the setscrews,turn the TILT
CRANK slightly.
2. ROTATE the STOP COLLAR moving it away from
pivot nut.
3. TILT blade RIGHT or LEFT . . , checking with your
square until blade issquareto table.
4. ROTATE STOP COLLAR moving it toward PIVOT
NUT until it TOUCHES the PIVOT NUT... TIGHTEN
the setscrews.
5. Check POINTER. If it DOES NOT point to the "0"
mark on the bevel scale . . . loosen screw and adjust
pointer.
BLADE COVERED
WITH PIECE OF
CARDBOARD
VIEW FROM UNDERNEATH SAW
/
I
I
/
SETSCREWS(2)
PIVOT NUT
\
90° STOP COLLAR
TILT blade to LEFT as far as it will go. It will stop when
the PIVOT NUT is against the 45 ° STOP COLLAR ... and
the pointer SHOULD POINT to the "45" mark on the
bevel scale.
If POINTER DOES NOT POINT to the "45" mark.., the
45 ° STOP COLLAR must be ADJUSTED.
1. TILT blade all the way to the RIGHT.
2. Remove BLADE GUARD and BLADE.
3. Reach inside of saw from top.., loosen both setscrews
in 45° STOP COLLAR.
4. ROTATE collar moving it toward end of tilt screw.
5. TILT blade until POINTER points to "45" mark.
6. Reach UNDERNEATH saw . . rotate COLLAR
moving it against PIVOT NUT . . . TIGHTEN the
setscrews. Pivot nut is visible through curved slot in
front of saw.
NOTE: If you can't reach the setscrews, turn TILT
CRANK slightly.
STOP4_OLLAR
TILTSCREW
BACK OF SAW
25
Loading ...
Loading ...
Loading ...